How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST

This instruction show you guide on how to do transmission computer flashing after it replaced via ODIS Engineering on VW Passt.

Preparation:

Newest ODIS-E Engineering 12.1.1 & 9.0.4 Free Download

How to Install ODIS-Engineering 12.1.0 Diagnostic Software

Steps

Before replace new computer, Connect vehicle and ODIS Engineering Software, then running it.

Select diagnostic data of vehicle model–>”0002-Transmission computer”–>”001 Identify”
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-1

Take photos and save for comparison after flashing
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-2

Select “0002-Transmission computer”–>”003 Measurements”
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-3

Input “41” on Measured value block position, click “Application”, then click blue tick on the downright side.
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-4

“V069AG110AM_getrebe_DSG jDAG” is the original flash package
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-5

After replace computer, select “0002-Transmission computer”–>”042 flash”
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-6
Select “02_local refresh file” , open the directory where the database is located_all files, search v069AG when it is found that the flash file package is not exactly the same as the original car, you can choose the closest to the original car package for flashing.
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-7

After selection, click flash.

After flashing, “0AM300064T” will change to “0AM3000061A”
How to Flash Transmission Computer after Replaced by ODIS Engineering for VW PASST-8
Function is ready.

Be the first to comment

Leave a Reply

Your email address will not be published.


*