GM TCM & transfer case programming/coding with SPS & TIS

Here is the Coding/Programming TCM and Transfer Case Tutorial for 2015 Chevrolet Suburban from MaxiFlash JVCI and Autel IM608 with PLC and Software Global TIS.

Difference between Programming and Coding:

1)Flash Programming
Install a new blank module in your vehicle from dealers
Buy and download software to PC from manufacturers
Pass the data into the ECU from PC to vehicle via J-box.

2)Coding
After Flashing/programming, match or configure components directly from your scanner.

Procedures
1. Flash Programming
Start “SPS”.
Click “J2534 Tool” “Reset J2534 Tool” “Replace and Reprogram ECU” and Next.
GM TCM transfer case programming coding with SPS TIS-1 (2)

Then we have some preconditions.
GM TCM transfer case programming coding with SPS TIS-2 (2)

Go on and select vehicle info and our JVCI – (Autel MaxiIM IM608) MaxiFlash JVCI J2534 ECU Reprogrammer. (You can use other J-boxes like WIFI GM MDI, WIFI GM MDI2, VXDIAG VCX NANO for GM/Opel etc.)
GM TCM transfer case programming coding with SPS TIS-3 (2)

Here your JVCI will blink, communicating with your vehicle. (If it shows E4399/E4403 error, the possible reason is communication loss)
Then scroll down to “Transmission Control Module”.
GM TCM transfer case programming coding with SPS TIS-4 (2)
Confirm some info and start Flash Programming, typically it takes less than 5 minutes.
GM TCM transfer case programming coding with SPS TIS-5 (2) GM TCM transfer case programming coding with SPS TIS-6 (2)

Then repeat again and select “Transfer Case Control Module” to flash it.

2. Coding
1)Transfer Case Module Coding
Turn on Autel IM608. (Other scanners are okay as well)

Go to
Diagnostics>>Auto detect
After confirming car information, we enter the main menu.

Select

Diagnosis>>Control unit>>Transfer case control module>>Special function>>Range actuator learn
Follow the instruction.
GM TCM transfer case programming coding with SPS TIS-7 (2) GM TCM transfer case programming coding with SPS TIS-8 (2) GM TCM transfer case programming coding with SPS TIS-9 (2)

2)Transmission Control Module Coding
Back to main menu.

Select

Diagnosis>>Control unit>>Transmission control module>>Special function>>Transmission adaptive pressure reset
Here we need to start our vehicle to check if it’s correct.
GM TCM transfer case programming coding with SPS TIS-10 (2)

Click on “Reset” if it’s done.

Alright, that’s how we flash/code Transmission Control Module(TCM) and Transfer Case Module.

Hope this article is helpful.
UK Professional OBD2 Tools Online Shop

Be the first to comment

Leave a Reply

Your email address will not be published.


*