How to Program Injectors for Caterpillar C7 Engine with CAT Caterpillar ET Diagnostic Adapter III?

November 4, 2020 Eva Heavy Duty Diagnostic 0

How to Program Injectors for Caterpillar C7 Engine with CAT Caterpillar ET Diagnostic Adapter III?

2020A is an upgraded version of 2019C , A represents the first quarter, and C is the software updated in the third quarter.

2020A Cat ET software as Cat Caterpillar ET 2018C 2019A 2019C Software update version, 20120A Caterpillar Electronic Technician softwarer With CAT ET 3 Cat caterpillar adapter 3 support caterpillar diagnostic till 2020.

Procedures:

Connect CAT3 interface to DLC,and then run CAT ET diagnostic software and build connection

Select “Service” calibration function
11.1
Perform injector replacement programming,and click “Change”
11.2
Load the injectors matched trim files
11.3
Warning message!

Emissions could be affected if the wrong injector trim file is selected.Are you sure you want to program this injector?

Click “Yes”
11.4
Injector Trim successfully programmed.
11.5

Related posts:

  1. How to Program Injectors for Caterpillar C7 Engine with CAT Caterpillar ET Diagnostic Adapter III?
  2. How to Create New Caterpillar Injector Trim Files with CAT Caterpillar ET Diagnostic Adapter III?
  3. Caterpillar ET 2020A (replaces CAT ET 2019C, 2019B) Electronic Technician Diagnostic Software
  4. Caterpillar ET 2020A (replaces CAT ET 2019C, 2019B) Electronic Technician Diagnostic Software

Be the first to comment

Leave a Reply

Your email address will not be published.


*